-
Introduction
-
Basics
-
Setup for VIVE Focus Vision, VIVE XR Elite, and VIVE Focus 3
-
Setup for SteamVR-compatible headsets
-
Solutions and FAQs
-
General
- Troubleshooting VIVE Ultimate Tracker
- Can VIVE Ultimate Tracker enter pairing mode immediately after turning it on?
- Why can't I pair new trackers?
- Why am I experiencing stuttering in my PC VR streaming session while using VIVE Ultimate Tracker?
- Why is the status LED on the tracker continuously breathing green?
- Is there a way to restart the tracker?
- Why can't I see tracker information in settings?
- What should I do if I'm having problems connecting VIVE XR Elite with VIVE Ultimate Tracker?
- What should I do if I'm using VIVE Location-Based Software Suite (LBSS) with VIVE Focus 3?
- How do I set up full-body tracking in VRChat?
-
Tracking
-
- Contact Us
Attaching the VIVE Wireless Dongle to VIVE Focus Vision or VIVE Focus 3
Connect the dongle to the headset to use
VIVE Ultimate Tracker.
Important: Use the extension cable and cable fastener that come in the box to attach the dongle to your headset. Don't plug the dongle directly into the USB port on the right side of the headset.
-
Thread the USB extension cable through the cable fastener.
-
Connect the dongle to the USB extension cable.
-
Connect the L connector of the USB extension cable to the USB port on the right side of the headset.
-
Secure the cable by wrapping the hook-and-loop tape around the headset's right band.
Note: Make sure the hook-and-loop tape doesn't cover the speakers.
Warning: Connect the dongle directly to the USB extension cable that comes in the box. Avoid using a USB hub or splitter, as unusual power behavior could damage the dongle.
Was this helpful?
Yes
No
Submit
Thank you! Your feedback helps others to see the most helpful information.