How do I reassemble the headset after repair?

After receiving your repaired headset, reattach the accessories to your headset in the following order:

Audio cable
Headset cable
On-ear headphones and side cushions
Top strap
Front pad
Back pad
Face cushion frame with cushions
Front cover (faceplate)

While holding the visor with one hand, lift the headset band.
Connect the audio cable to the headset:
- Plug the audio jack into the audio port above the right lens.
- Align the audio cable stopper with the slot and press it gently into place. Then press the cable into the lower of the two horizontal grooves.
Connect the headset cable.
Attach the on-ear headphones:
- Flip open the metal clasps on the left and right headphones.
- Follow the steps in these topics to attach the on-ear headphones and connect the audio cable:
Attach the side cushions to the headset band.
Make sure that each side cushion is aligned with the curvature on the band.
Attach the top strap to the headset. See Attaching the top strap to the headset band.
Attach the front and back pads. See Reattaching the front and back pads to the headset.
Attach the face cushion frame.
Align the tabs with the slots on the headset, and then gently push them into place. You'll hear a click when the frame locks in place.
Attach the front cover. Follow steps 4 and 5 in Replacing the front cover.

Was this helpful? Yes No

Submit

Thank you! Your feedback helps others to see the most helpful information.