-
Introduction
-
Tracking modes
-
ArUco markers and marker-based tracking features
-
ArUco markers
-
Marker-based tracking features
-
-
Marker-Based Location Sharing setup
- Setting up Marker-Based Location Sharing
- Creating ArUco markers for Marker-Based Location Sharing
- Aligning the height of a virtual scene using an ArUco marker
- Moving a user to a specific point in a virtual scene
- Setting up Marker-Based Location Sharing with VIVE Business Streaming
- Marker-Based Location Sharing APIs (AIO)
- Marker-Based Location Sharing APIs (PC VR)
-
LBE Mode/LBE Hybrid Mode setup
-
LBE map configuration
-
Marker-Based Drift Prevention setup
-
Marker-Based Advanced Relocation setup
-
Marker-Based Scene Alignment setup
- Setting up Marker-Based Scene Alignment
- Configuring the position of an ArUco marker in a virtual scene (Unity)
- Creating ArUco markers for Marker-Based Scene Alignment
- Setting up Marker-Based Scene Alignment with VIVE Business Streaming
- Marker-Based Scene Alignment APIs (AIO)
- Marker-Based Scene Alignment APIs (PC VR)
-
Simulator VR Mode setup
- Setting up Simulator VR Mode
- Pairing wrist trackers with a headset
- Installing an anchor controller or tracker in a VR simulator
- Coordinate alignment
- Anchor controller and tracker origin points
- Aligning VR and anchor coordinate systems using a VR controller
- Aligning VR and anchor coordinate systems using an ArUco marker
- Simulator VR Mode FAQs
-
Other services
-
Additional features
- Contact Us
Setting up the play area for map creation
Divide your play area into visibly marked square sections before creating your map.
Mark the borders of each section. Try to make each section roughly the same size.
The size of each section will depend on the total area of the space you're using. We recommend applying tape to the borders to make identifying the sections easier while scanning.
-
For a space with a total area of 500 square meters, each section should be about 16 square meters, or about 4 meters long on each side.
-
For a space with a total area of 1000 square meters, each section should be about 36 square meters, or about 6 meters long on each side.
-
For spaces smaller than 20 square meters, you can start the scan from any section, as long as all sections are scanned consecutively. However, for larger spaces, we recommend scanning the sections in a specific order. Here are some examples:
Was this helpful?
Yes
No
Submit
Thank you! Your feedback helps others to see the most helpful information.