Marker-based tracking features
Marker-Based Location Sharing setup
- Setting up Marker-Based Location Sharing with one ArUco marker
- Setting up Marker-Based Location Sharing with two ArUco markers
- Creating ArUco markers for Marker-Based Location Sharing
- Aligning the height of a virtual scene using an ArUco marker
- Moving a user to a specific point in a virtual scene
- Running Marker-Based Location Sharing with VIVE Business Streaming
- Marker-Based Location Sharing APIs (AIO)
- Marker-Based Location Sharing APIs (PC VR)
- Marker-Based Location Sharing JSON files
LBE Mode/LBE Hybrid Mode setup
LBE map configuration
Marker-Based Drift Prevention and Marker-Based Relocation setup
Marker-Based Scene Alignment setup
Simulator VR Mode setup
- Setting up Simulator VR Mode
- Pairing VR controllers with a headset
- Pairing wrist trackers with a headset
- Installing an anchor controller or tracker in a VR simulator
- Coordinate alignment
- Anchor controller and tracker origin points
- Aligning VR and anchor coordinate systems using a VR controller
- Aligning VR and anchor coordinate systems using an ArUco marker
- Simulator VR Mode FAQs
Apps and services
- Contact Us
Installing an anchor controller or tracker in a VR simulator
An anchor controller or tracker assists in motion compensation when used with a headset set up for Simulator VR Mode.
Anchor controllers or trackers can only be used with supported VR simulators.
- Install the left controller or wrist tracker in front of where the user will be seated inside the simulator or vehicle. Make sure the controller or tracker is secure.
- Put on the headset, making sure that the anchor controller or tracker stays within the headset's field of view (FOV).
Note: For optimal tracking performance, make sure the anchor controller or tracker is installed at least 40 cm away from the headset.
Was this helpful? Yes No
Thank you! Your feedback helps others to see the most helpful information.