-
1.0 Fall Protection
-
1.1 Lesson Selection (Main Hub)
-
1.2 Lesson One - Gear Selection
-
1.3 Lesson Two - Training Room
-
1.4 Lesson Three - Equipment Retrieval
-
-
2.0 Confined Space
-
2.1 Lesson Selection (Main Hub)
-
2.2 Lesson One - Gear Selection
-
2.3 Lesson Two - Training Room
-
2.4 Lesson Three - Gas Leak
-
-
3.0 Lockout Tagout (LoTo)
-
3.1 Lesson Selection (Main Hub)
-
3.2 Lesson One - Gear Selection
-
3.3 Lesson Two - Training Room
- About Training Room
- Setup 1: Select all equipment needing LoTo - Part 1
- Setup 2: Select all equipment that needs LoTo - Part 2
- Setup 3: Select all equipment that needs LoTo - Part 3
- Setup 4: Radio to notify affected workers
- Setup 5: Apply and remove LoTo - Circuit Breaker Switch and Valve
- Setup 6: Release residual energy and verify
- Scoring
-
3.4 Lesson Three - Factory Site
- About Factory Site
- Step 1: Use Radio to Notify Affected Employees
- Step 2: Turn off the Power Switch, and Turn off Circuit Breaker Switch 3, then LoTo
- Step 3: Confirm Electrical Power Source Is Turned off
- Step 4: Release any Residual Energy
- Step 5: Services the Pump with the Wrench
- Step 6: Remove LoTo, and Open Main and Residual Pressure Valve
- Step 7: Remove LoTo and Turn on Circuit Breaker Switch 3
- Step 8: Notify Coworkers that Work Is Done
- Step 9: Power on the Pump
- Scoring
-
- Contact Us
Scoring
When the last setup is complete, the trainee is returned to the Main Hub and shown their score on the console screen.
The following will appear, with each setup marked as
GOOD in green or
BAD in red:
Gas Leak Completed A - F
Press STOP to go back to the main menu.
| Selected Good Gear | GOOD/BAD |
| Read The Permit | GOOD/BAD |
| Didn't Enter Unsafe Space | GOOD/BAD |
| Didn't Fall | GOOD/BAD |
| Didn't Lose Equipment | GOOD/BAD |
| Correctly Used Air-Blower | GOOD/BAD |
| Correctly Used Gas-Meter | GOOD/BAD |
| Called For Assistance | GOOD/BAD |
| Called For Help | GOOD/BAD |
| Shut Down Possible Gas Leak | GOOD/BAD |
Letter grades are based on the number of failed setups:
- 0 Setups Failed = A
- 1 - 3 Setups Failed = B
- 4 - 6 Setups Failed = C
- 7 - 9 Setups Failed = D
- 10 Setups Failed = F
Pressing STOP after the score appears on the screen returns the trainee to the lesson selection screen.
Was this helpful?
Yes
No
Submit
Thank you! Your feedback helps others to see the most helpful information.