-
1.0 Fall Protection
-
1.1 Lesson Selection (Main Hub)
-
1.2 Lesson One - Gear Selection
-
1.3 Lesson Two - Training Room
-
1.4 Lesson Three - Equipment Retrieval
-
-
2.0 Confined Space
-
2.1 Lesson Selection (Main Hub)
-
2.2 Lesson One - Gear Selection
-
2.3 Lesson Two - Training Room
-
2.4 Lesson Three - Gas Leak
-
-
3.0 Lockout Tagout (LoTo)
-
3.1 Lesson Selection (Main Hub)
-
3.2 Lesson One - Gear Selection
-
3.3 Lesson Two - Training Room
- About Training Room
- Setup 1: Select all equipment needing LoTo - Part 1
- Setup 2: Select all equipment that needs LoTo - Part 2
- Setup 3: Select all equipment that needs LoTo - Part 3
- Setup 4: Radio to notify affected workers
- Setup 5: Apply and remove LoTo - Circuit Breaker Switch and Valve
- Setup 6: Release residual energy and verify
- Scoring
-
3.4 Lesson Three - Factory Site
- About Factory Site
- Step 1: Use Radio to Notify Affected Employees
- Step 2: Turn off the Power Switch, and Turn off Circuit Breaker Switch 3, then LoTo
- Step 3: Confirm Electrical Power Source Is Turned off
- Step 4: Release any Residual Energy
- Step 5: Services the Pump with the Wrench
- Step 6: Remove LoTo, and Open Main and Residual Pressure Valve
- Step 7: Remove LoTo and Turn on Circuit Breaker Switch 3
- Step 8: Notify Coworkers that Work Is Done
- Step 9: Power on the Pump
- Scoring
-
- Contact Us
Step 2: Turn off the Power Switch, and Turn off Circuit Breaker Switch 3, then LoTo
The trainee should turn off the Power Switch next to the pump by pressing the Power button, and then turn off Circuit Breaker Switch 3 by going into the electrical panel room (Area 2) and pulling down Switch 3.
The trainee should lock and tag it with the switch lock and tag found in the locker.
If the trainee does not turn off the circuit breaker switch, or if they pull the wrong switch, they will automatically fail when servicing the pump. The pump will also be damaged. This will result in BAD grades for Didn't die from power surge and Didn't damage pump or other equipment.
If the trainee does not properly lock and tag the circuit breaker switch after turning it off, this will result in a BAD grade for Used locks and tags correctly.
Was this helpful?
Yes
No
Submit
Thank you! Your feedback helps others to see the most helpful information.