-
1.0 Fall Protection
-
1.1 Lesson Selection (Main Hub)
-
1.2 Lesson One - Gear Selection
-
1.3 Lesson Two - Training Room
-
1.4 Lesson Three - Equipment Retrieval
-
-
2.0 Confined Space
-
2.1 Lesson Selection (Main Hub)
-
2.2 Lesson One - Gear Selection
-
2.3 Lesson Two - Training Room
-
2.4 Lesson Three - Gas Leak
-
-
3.0 Lockout Tagout (LoTo)
-
3.1 Lesson Selection (Main Hub)
-
3.2 Lesson One - Gear Selection
-
3.3 Lesson Two - Training Room
- About Training Room
- Setup 1: Select all equipment needing LoTo - Part 1
- Setup 2: Select all equipment that needs LoTo - Part 2
- Setup 3: Select all equipment that needs LoTo - Part 3
- Setup 4: Radio to notify affected workers
- Setup 5: Apply and remove LoTo - Circuit Breaker Switch and Valve
- Setup 6: Release residual energy and verify
- Scoring
-
3.4 Lesson Three - Factory Site
- About Factory Site
- Step 1: Use Radio to Notify Affected Employees
- Step 2: Turn off the Power Switch, and Turn off Circuit Breaker Switch 3, then LoTo
- Step 3: Confirm Electrical Power Source Is Turned off
- Step 4: Release any Residual Energy
- Step 5: Services the Pump with the Wrench
- Step 6: Remove LoTo, and Open Main and Residual Pressure Valve
- Step 7: Remove LoTo and Turn on Circuit Breaker Switch 3
- Step 8: Notify Coworkers that Work Is Done
- Step 9: Power on the Pump
- Scoring
-
- Contact Us
Setup 2: Deploy Gas Meter in Horizontal Confined Space
The following appears on the console screen:
Walk over to confined space entrance and take your gas meter and hold it in your hand.
A blue destination circle will appear on the ground in front of the confined space. When the trainee walks to it, it disappears and a positive beep plays.
The following appears on the console screen:
Push calibrate button on gas meter.
The trainee must push the blue CALIRABTE button on the 5-gas meter, a positive beep plays, and then the following text appears on the console screen:
With the other hand, take the sensor of the gas meter and place it close to confined space entrance to measure its atmosphere. Read the values from gas meter.
The trainee must then take the 5-gas meter and place it into the confined space. The readings will indicate if the confined space is safe.
If safe, the circle on the meter screen will turn green, and a positive beep will play.
If not safe, the circle on the 5-gas meter screen will turn red, and a negative buzz will play.
The following appears on the console screen:
When you're confident you've seen enough you can place gas meter back to the belt. Is it safe to enter? Please select your answer below.
The trainee must answer by pushing the blue YES or NO buttons under the console screen. If the trainee waits too long, the setup will reset, and they must measure the atmosphere in the confined space again.
Once the trainee responds, the next setup will begin, regardless of correctness.
If the trainee answers correctly, the setup completes and is marked as successful if no other fail conditions were triggered.
If the trainee answers incorrectly, the setup completes and is marked as failed.
If gas meter is dropped from the platform, the setup is marked as failed. It respawns and the trainee must still complete the setup.